Fairbanks 1129 SERIES Dual Platform Counting Scale - Manual (Page 23)

Section 4: User Operations
08/12 23 51300 Rev. 1
4.3.2. Counting by Piece Weight
The Omega Counting Scale counts items by their Piece Weight.
– If the weight of each item is known, the items are counted based upon the
weight upon the scale.
A WORKING EXAMPLE
There are ten (10) pounds of bolts on a scale. Each bolt weighs a tenth of a pound
(0.10 lbs.) The scale performs an internal calculation and displays one hundred
(100) on the third
PIECES line on the display.
There are two ways to set the Piece Weight.
 Keypad input.
 Sampling.
The ACC KEY saves all current data.
– It records the weight and piece data into memory.
– After any record is saved, the scale weighing pan must be cleared to ensure
the weight is at zero for the next record.
4.4. TARE OPERATIONS
4.4.1. Auto Tare Entry
1. While in the Weigh Mode, place the container on the scale pan.
2. Press the key.
– The tare weight has been stored.
3. is displayed.
IMPORTANT NOTE: The Tare Weight cannot be set when the Displayed
Weight is less than zero.