Avanti OCR43SS - Manual (Page 9)

9
INSTALLATION INSTRUCTIONS
? Before Using Your Appliance
?
Remove the exterior and interior packing.
?
Check to be sure you have all of the following parts:
?
1 Bake/Broil/Drip Pan
?
1 Bake/Broil/Drip Handling Tool
?
1 Oven Wire Rack
?
1 Rotisserie Skewer Handling Tool
?
2 Rotisserie Forks with Screws
?
1 Rotisserie Skewer
?
1 Instruction Manual
?
Remove all the items inside your oven and clean the interior surface with lukewarm water using a
soft cloth.
?
Do not attempt to repair or replace any part of your oven unless it is specially recommended in
this manual.
?
This appliance requires 1400W and should be the only appliance operating on the same circuit.
? Installation of Your Appliance
Select a location for the appliance. The location should be in an open area on a flat counter where
the plug will reach an outlet.
?
When positioning the appliance, it should be set on a flat, steady surface.
?
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually
cause the appliance failure.
?
Keep the appliance away from hot air, steam or splashing liquids when choosing a place to locate it,
otherwise, the unit’s operation may be adversely affected, causing it to break down.
?
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
?
Plug the appliance into an exclusive properly installed grounded wall outlet. Any questions
concerning power should be directed toward a certified electrician or an authorized Avanti Products
service center.
?
Do not place anything on the top of the broiler oven and automatic toaster.
?
Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.
NOTICE
Before you use this oven for the first time: The heating elements have a protective coating, which
must be burned off before use. To do this, open the oven door and set the temperature control knob to
250
°C/480°F. Move the function selector to toast and rotate the timer control knob to approximately 15
minutes. It is important to ensure adequate ventilation during this period.