Finish Thompson LS-JRE - Manual (Page 2)

INTRODUCTION
This “LS-JrE” solvent recycling system is designed to safely recycle contaminated solvents on-site using a thermal distillation
process. When properly installed and operated, the LS-Jr provides long, trouble-free service, and can typically recover five gallons
of solvent in eight hours. The LS-Jr is capable of processing most solvents with boiling points between 100°F and 320°F. If your
solvent’s boiling point is between 320°F and 500°F, the optional LS-JrVac must be used. Consult the LS-JrVac manual for further
information.
SAFETY PRECAUTIONS
WARNING: FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
• Installation location and area must conform to requirements set by National Electric Code Class 1, Division 1, Group D for
hazardous locations.
• Remove any ignition sources from the area such as flames (cigarettes, torches, furnace), or sparks (grinders, non-explo-
sionproof electrical switches and outlets, etc.).
• Follow National Fire Protection Association guidelines for control of static electricity (NFPA 77, Recommended Practice on
Static Electricity). This applies to the installation area, equipment, and all transfer and receiving containers.
• Ventilate all vapors from the processing area and distillation equipment according to National Fire Protection Association
guidelines (NFPA 91, Standard for the Installation of Blower and Exhaust Systems for Dust, Stock, and Vapor Removal or
Conveying).
• Follow the National Fire Protection Association recommendations for safe storage and use of flammable and combustible
liquids ( NFPA 30, Flammable and Combustible Liquids Code).
• Electrical wiring should be performed by a qualified electrician and must conform to National Electric Code Class 1, Division
1, Group D requirements for explosion-proof equipment. Use only electricals labeled explosion proof (boxes, receptacles,
hard conduit, etc.) for the installation and in the area.
• Obtain approval of the installation from your insurance and/or fire inspector prior to operation.
• Verify proper water flow before operation to prevent accumulation of hazardous vapors.
• Wear proper eye and skin protection when handling solvents.
• Never process reactive solvents such as gasoline, ethers, nitrocellulose, etc.
• Never open a hot still.
INSTALLATION & SET-UP
SUPPLIED PARTS AND ACCESSORIES
The following is a checklist of the items supplied with the LS-Jr. Be certain that you have everything you need for proper installation
and operation. In addition to these supplied items, you will need to provide your own electricals, plumbing fixtures, and receiving
vessel.
2