General Pump SK Repair Manual - Manual (Page 22)

GENERAL PUMP
A member of the Interpump Group
SK SERIES
The bearing in fig. 71 has a conical internal ring. Verify that the conicity is from the outside
to the inside, to allow the subsequent insertion of the bushing.
Apply the O-ring to the outside of the bearing support cover (1, fig. 72).
Page 22
Repeat the operation with the other cover.
Lock the three connecting rod assemblies, using the special device (part #F27566200) (`, fig. 41). Apply two
M16 threaded pins to the end of the crankshaft and, while keeping it raised (1, fig. 73), insert the bearing
support cover complete with bearing and O-ring (1, fig. 74) using a mallet or striking hammer. Repeat the
operation on the other side.