Installation instruction, Parts list – Heat Storm 23II200GRA User Manual

Page 4

Advertising
background image

INSTALLATION INSTRUCTION

E-3

Figure 2

REAR VIEW OF FIREPLACE

INSERT

MOUNTING

BRACKET

Position your completed mantel close to its

final location. Make sure you can access the back of

the mantel as your Electric Fireplace Insert will be

installed from the back.

Using a Phillips head screwdriver, remove the screws

and the metal mounting brackets attached on either

side of the fireplaces center opening. Next unpack

the Electric Fireplace Insert carefully. Position the insert

behind the fireplace with front facing the wood mantel.

With the help of an adult assistant, lift the Insert and

gently slide it into the opening in the mantel until the

flange is flush against the inside of the mantel. Make

sure insert is centered left and right in the opening. Be

careful when placing insert and adjusting, bottom of

insert could scratch the finish of the base/hearth

of your fireplace. Re-attach the mounting brackets

with the Phillips head screwdriver, and supplied

screws. DO NOT OVER TIGHTEN.

With the help of an assistant, carefully lift completed

unit and place it with the front facing out in the final

location you have chosen for your fireplace.

Make sure to secure the electrical cord before lifting

or moving completed fireplace. When choosing a final

location, make sure you will have clear access to a

grounded electrical outlet.

Read and follow all instructions in this manual before

operating your new fireplace.

ELECTRIC

FIREPLACE

INSERT

Part Name

23II200GRA

PARTS LIST

Emberbed
Blower Assembly

Infrared Heater Assembly

Control Panel - 6 Buttons

Main PCBA

Control Panel Circuit Board

Front Projection Screen

Flame Generator Drive Motor

Flame Generator/Spinner

Decorative Brick Panels
Remote Control - 6 Buttons

Advertising
This manual is related to the following products: