Kasco Marine 4400HJF - Manual (Page 10)

10
Sequoia Display:
The Sequoia nozzle is not marked and uses the shorter
3/8” x 2.25”
Model Height Width
3400JF/HJF 7’ 4’
4400JF/HJF 9.5’ 6’
Installation Instructions
Use the ropes to position the Fountain in the desired
location in the pond/lake. Anchor the ropes or secure
them to the shoreline so the ropes are free of slack, but
not tight. To prevent twisting of the unit due to torque,
you should place the anchor at least 3 feet from the
float for each foot of depth (Ex. A 6 foot deep pond
would require an anchor 18 feet horizontally from the
float.)
ALTERNATE INSTALLATION
In ponds where the water level fluctuates significantly,
you may need to suspend a small weight (12” of 1”
galvanize pipe works well) at the mid-point of the
rope to take up any slack as the water level drops. The
weight should be light enough so the Fountain can rise
as the water level rises. This can also help hide ropes
by sinking them further below the surface.
Linden Display:
The Linden nozzle (marked L inside one of the fins)
uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 6’ 18’
4400JF/HJF 8’ 25’
Willow Display:
The Willow nozzle (marked W on the inside of the
cone) uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 4.5’ 15’
4400JF/HJF 6’ 23’
Juniper Display:
The Juniper nozzle (marked with J on in inside of the
nozzle cone) uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 3’ 20’
4400JF/HJF 4’ 27’