Kasco Marine Horizontal Float - Manual (Page 2)

STEP FIVE
With a felt-tip marker, draw three to four marks
around the circumference of the motor housing at the
appropriate measurement from the back (or bottom)
of the motor housing
given below:
Model F2400: 3/4”
Model F3400: 3-3/8”
Model 4400: 3-3/8”
Model 8400: 3-1/4”
STEP SIX
Place the two U-Brackets directly across from each
other (180
O
) over the top ring of the motor cage. The
cord clamp on the cage should be 90
O
from each of
the U-Brackets. (See pictures on next page)
Models F2400, F3400
and 4400 - Angle
posterior to bolts.
Model 8400 - Angle
anterior to bolts.
STEP SEVEN
Insert the Spacer Bracket under the U-Bracket and
inside the cage. Secure this assembly using one 1/4”
x 1” Bolt and a 1/4” Lock Nut, and one 1/4” x 1-1/4”
Bolt and a 1/4” Hex Nut. The longer bolt should be
on the side of the U-Bracket that is closer to the cord
clamp. Tighten the hardware using the 7/16” wrench
and socket & wrench until the U-Bracket clamps
firmly around the cage (U-Bracket should pull to-
gether slightly). Repeat with the second U-Bracket.
STEP EIGHT
Attach an Angle Bracket to each of the longer (1-
1/4”) bolts on the U-Brackets (See photo for orienta-
tion) with a 1/4” Lock Nut.
STEP NINE
Wrap the Draw Band around the motor housing and
position so that the back of the Draw Band touches
the marks drawn in Step Five. There is no front or
back to the Draw Band itself - it is reversible. Orient
the arm of the Draw Band so it aligns with the cord
clamp on the cage of the motor housing and is paral-
lel to the Angle Brackets attached in Step Eight. Se-
cure using a 1/4” x 1” Stainless Steel Bolt and a 1/4”
Lock Nut. (See photo on next page.)
Models F2400, F3400
and 4400
Model 8400