King Kooker Bolt Together Cookers - Manual

Bottom Nut
Top Nut
Legs bolt to
outside of ring
(3 legs)
Legs bolt to
inside of shroud
(6 bolts, nuts,
lock washers,
flat washers)
Ring bolts to
inside of leg
Flat Bar
Shroud
Top of Cooker
1) Assemble the bolts, washers, and nuts as per the diagram.
2) Wrench tighten. Make sure all 12 bolt sets are used, and that the unit stands sturdily.
3) Refer to Use & Care Manual for instructions, lighting, and use of your cooker.
Installation of Casting:
1) Remove top nut from casting bolt.
Leave bottom nut attached and tightened.
2) Flip cooker upside down.
Insert casting with the bolt pointed up through
the shroud opening.
3) Place the casting bolt through the hole on the
flat bar.
4) Reinstall nut to casting bolt. Tighten.
5) Turn cooker right side up. Check to see if casting
is pointing straight up and is sturdy.
TOOLS NEEDED
• Adjustable Wrench
• Screwdriver
CONTENTS
(2) Rings
(3) Legs
(1) Shroud
(1) Casting
(1) Hose/
Regulator
(1) Windshield
(1) Spring
(12) Lock Washers
(12) Flat Washers
(12) Nuts
(12) Philips Head Bolts
ASSEMBLY INSTRUCTIONS
For Bolt Together Cooker
P atented reces s ed top ring des ign.
M e ta l F u s io n , In c . • 7 12 S t. G e o r g e A v e . , J e f f e r s o n , L A 7 0 12 1 • 1- 8 0 0 - 7 8 3 - 3 8 8 5
Read and Understand the Assembly Instructions and Use & Care manual
which was included with this cooker package, as well as the Assembly
Directions below. If you need a copy of the manual, please call
1-800-783-3885 for a replacement.
Phillips Head Bolt
Flat Washer
Lock Washer
Nut