Ransburg MMA-570 Direct_Ind Charge Atomizer A13366 - Manual (Page 62)

Splash Plate Removal (All Bell Cups)
After removing the bell cup from the applicator, put
it on a plastic or wood surface to prevent damage
to the edge of the cup. Using the splash plate
removal tool (A11388-00), insert the small end of
the tool into the end of the splash plate assembly.
Press the splash plate out. It may be necessary
to tap lightly with a hammer.
Splash Plate Removal
Splash Plate Insertion (All Bell Cups)
Turn the splash plate removal tool over and use
the large diameter end to press the splash plate
back in place by hand. It may be necessary on
occasions to use an arbor press to install the
splash plate. Press splash plate to a hard stop
(see “Splash Plate Insertion” figure).
Splash Plate Insertion (30mm)
C A U T I O N !
† Failure to replace a damaged bell cup
will cause vibration of the applicator and/or
premature turbine failure.
MMA-570 Direct/Indirect Charge - Maintenance
Ransburg
LN-9279-13 59