Ransburg Serial Atomizer Module A11925-00 - Manual (Page 6)

LN-9256-07.4
Serial Atomizer Module - Safety
3 3 3 3 3
A R E A A R E A A R E A A R E A A R E A
Tells where hazards
may occur.
HAZARD HAZARD HAZARD HAZARD HAZARD
Tells what the hazard is.
SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS
Tells how to avoid the hazard.
Improper operation or maintenance
may create a hazard.
Personnel must be properly trained
in the use of this equipment.
Personnel must be given training in accordance with
the requirements of NFPA-33.
Instructions and safety precautions must be read
and understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, operation
maintenance, and housekeeping. Reference OSHA,
NFPA-33, and your insurance company requirements.
General Use and General Use and General Use and General Use and General Use and
Maintenance
Maintenance Maintenance Maintenance Maintenance
Electrical Electrical Electrical Electrical Electrical
Equipment
Equipment Equipment Equipment Equipment
High voltage equipment is uti-
lized. Arcing in areas of flam-
mable or combustible materials
may occur. Personnel are ex-
posed to high voltage during
operation and maintenance.
Protection against inadvertent
arcing that may cause a fire or
explosion is lost if safety circuits
are disabled during operation.
Frequent power supply shut-
down indicates a problem in the
system which requires correc-
tion.
An electrical arc can ignite coat-
ing materials and cause a fire or
explosion.
The power supply, optional remote control cabinet,
and all other electrical equipment must be located
outside Class I or II, Division 1 and 2 hazardous
areas. Refer to NFPA-33.
Turn the power supply OFF before working on the
equipment.
Test only in areas free of flammable or combus-
tible material.
Testing may require high voltage to be on, but
only as instructed.
Production should never be done with the safety
circuits disabled.
Before turning the high voltage on, make sure no
objects are within the sparking distance.
Explosion Explosion Explosion Explosion Explosion
Hazard /
Hazard / Hazard / Hazard / Hazard /
Incompatible
Incompatible Incompatible Incompatible Incompatible
Materials
Materials Materials Materials Materials
Halogenated hydrocarbon solvents
for example: methylene chloride
and 1,1,1,-Trichloroethane are not
chemically compatible with the
aluminum that might be used in
many system components. The
chemical reaction caused by these
solvents reacting with aluminum
can become violent and lead to an
equipment explosion. Aluminum is widely used in other spray application
equipment - such as material pumps, regulators,
triggering valves, etc. Halogenated hydrocarbon
solvents must never be used with aluminum equip-
ment during spraying, flushing, or cleaning. Read
the label or data sheet for the material you intend
to spray. If in doubt as to whether or not a coating
or cleaning material is compatible, contact your
material supplier. Any other type of solvent may
be used with aluminum equipment.