Ransburg Aerobell M Rotary Atomizer 78101 - Manual (Page 11)

LN-9237-00.1
Aerobell M Rotary Atomizer - Introduction
7 7 7 7 7
> The high voltage equipment that is
used in this application creates a hazard
for personnel. The high voltage power
supply is not approved for use inside of
the spray booth, as defined in NFPA 33.
This high voltage power supply can
produce sparks which are capable of
igniting coating material.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
!!!!!
Insulator Support Rod Assembly Insulator Support Rod Assembly Insulator Support Rod Assembly Insulator Support Rod Assembly Insulator Support Rod Assembly
The air and fluid manifold assembly mount onto
the insulator support rod assembly, which in
turn is attached to the reciprocator or support
stand.
Rear Shroud Assembly Rear Shroud Assembly Rear Shroud Assembly Rear Shroud Assembly Rear Shroud Assembly
The rear shroud assembly consists of a rear
bulkhead which provides a passageway for fluid
and air tubes, mounting rods to connect the rear
bulkhead to the air and fluid manifold assembly,
a fluid regulator mounted onto the outside sur-
face of the rear bulkhead, and a resistor module
nested between the rear bulkhead and air mani-
fold assembly.
Resistor Module Resistor Module Resistor Module Resistor Module Resistor Module
The module encapsulates the high voltage re-
sistors necessary for control of the electrostatic
charge being fed to the bell through the high
voltage cable.
Power Supply and Power Supply and Power Supply and Power Supply and Power Supply and
Junction T
Junction T Junction T Junction T Junction Tank ank ank ank ank
The Aerobell M System operates with a variety
of high voltage power supplies. The power sup-
plies operate at output voltages of up to 100,000
volts DC. Also available is a junction tank which
is used to distribute high voltage to multiple
Aerobell M assemblies from a single power sup-
ply.
High V High V High V High V High Voltage Cables oltage Cables oltage Cables oltage Cables oltage Cables
The SSW-1064, high voltage cable, is used to
connect the power supply to the resistor module
inside the atomizer assembly.
Speed Monitor/Control Speed Monitor/Control Speed Monitor/Control Speed Monitor/Control Speed Monitor/Control
The Aerobell M rotary atomizer is designed to
operate with the ITW Ransburg PulseTrack
TM or
Atomizer Module for speed monitoring and/or
speed control.