Reversomatic HT 145 (Room to Room) - Manual

CONTRACTOR
ARCHITECT JOB
ENGINEER DATE SUBMITTED REVERSOMATIC Mfg. Ltd
Toronto, Ontario
DATE SUPERSEDES DRAWING NO.
HT145 TRANSFER FAN DETAIL
TRANSFER FAN HT145
INSTALLATION INSTRUCTIONS
TECHNICAL DATA
The housing is designed for easy installation and incorporates
a variable speed control with minimum and maximum settings
to obtain 55 to 145 C.F.M. Also included are two attractive
white enamel two way deflection grilles.
PARTS LIST
1. Speed Control Knob
2. Outlet Grille
3. 6-5/6” Plastic Fan Blade
4. Nut
5. Fan Housing
6. Side Selftaping Screw
7. Speed Control
8. Motor
9. Telescoping Sleeve
10.Inlet grille
10 9 4 8 7 6 5 3 2 1
Cut a hole in the wall 8.5” x 9” using telescoping
sleeve for the cutting in desired area of the wall
between studs or ceiling joists.
Please Note: The HT145 FAN can be installed verti-
cally or horizontally. Check air flow on diagram and
turn the fan to acquire desired direction of air flow.
Run 115/1/60 (normal house current) to the opening.
The fan comes complete with an on-off variable
speed controller. If the fan is within arms reach a sec-
ond switch is not necessary.
Install the sleeve only. leaving the grille unattached for
the moment. Secure the sleeve with 4 of the screws
provided. Remove the electrical cover in the fan and
insert the wire. Use a connector on the outside of the electrical cover in the fan and insert the wire. Use a con-
nector on the outside of the electrical box. Connect the fan leads to the supply wire and replace the electrical
cover. Install the HT145 FAN in place, joining the preinstalled sleeve. Once the fan and sleeve are in place,
secure the flange of the fan with 4 screws and secure the fan to the sleeve with remaining 2 screws if neces-
sary.
Install both grilles and your HT145 is ready to save you money.