Rivers Edge RE509 Big Foot XLT User Manual
Page 12
Check for parts online at
www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5
Check for parts online at
www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5
12
Operator's Manual
Rivers Edge Hang-On Stands
AssEMBlY INsTRuCTIONs (RE509)
Tools needed – two 7/16" wrenches
IMPORTAnT AssEMBLY TIP: do not tighten any nut and bolt combi-
nations completely until all parts are assembled together! Finger
tighten plus one turn of a wrench only! This will temporarily hold the
lock nut on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be com-
pletely tightened.
1. Bolt the metal seat frame (C30) onto the seat post (CXR25) using the
(2) provided 1/4-20 x 2-1/2" bolts, locknuts and (6) nylon washers.
sEE fIGuRE 1. DO NOT tighten all nut & bolt assemblies
completely!
2. Attach the tree hugger to the seat post using (1) provided 5/16-18
x 2" bolt, locknut and steel washer. sEE fIGuRE 1.
3. Bolt cables (48212) onto platform (CXR21) using the (2) provided
1/4-20 x 1-1/2" bolts, locknuts and steel washers. sEE fIGuRE 2.
You must now tighten all nut & bolt assemblies. Be sure not to
over tighten or crush tubing when tightening!
nOTE:
using powder graphite lubricant during assembly of moving parts
will help eliminate noise during use!
4. Insert the removable/pivoting armrests (CXR26) into each armrest
receiver on the seat post by pressing snap button inward and
snapping button into holes of receivers. sEE fIGuRE 3. Thread bolt
knob into treaded portion of receiver to tighten up armrest to help
prevent movement/noise.
Armrests can be inserted into receivers and positioned all four
directions if desired. Armrests can also be removed if desired.
Repositioning of armrest will allow for easier entry/exit into your
treestand and can make for a slimmer profile for backpacking.
Figure 1
1/4-20
x 2-1/2"
bolts
nylon washers
5/16-18 locknut
1/4-20 locknuts
nylon washers
nylon washers
5/16-18 x 2" bolt
steel washer
Figure 2
steel washer
locknut
platform cable
1/4-20 x 1-1/2" bolts
Figure 3
armrests
5/16-18 x 1/2" bolt knob
snap button
holes on each
side of receivers