Altinex Video Scaler Card MT106-103 - Manual (Page 10)

MULTITASKER
400-0394-007 9
Input: Composite Video
Output Resolution: 1024x768
Brightness: 24
Contrast: 40
Color: 24
Sharpness: 10
Hue: 0
3D Filter OFF
NR ON
Aspect Ratio 4:3
Freeze OFF
[SAVED]
3. [CLR]
Reset the card to its last saved settings.
Command Format: [CLRCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [CLRC4] to reset the card in
slot 4 to its last saved settings.
4. [FRESET]
This command clears the card’s memory and
returns the card to its factory default settings.
The factory defaults are as follows:
In = S-Video Brightness = 24
Res. = 1024x768 Contrast = 40
3D Filter = Off Color = 24
Noise Red. = On Sharpness = 10
Freeze = Off Hue = 00
Aspect Ratio 4:3
Command Format: [FRESETCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [FRESETC4] to reset C4 to
the settings described above.
Use the
command [C4S] to save the settings so they will
be recalled upon power-up, reset, or [CLRC4].
5. [VER]
This command displays the software version
and model number for the card.
Command Format: [VERCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [VERC4] to check the
version of the MT106-103 in slot 4. The system
will return the following feedback:
[MT106-103 690-0187-006 C04]
MT106-103 = Model Number
690-0187-006 = Firmware Version
C04 = Card ID
6. [HELP]
This command displays information available for
the MultiTasker interface commands.
Command Format: [HELPCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
In order to display the RS-232 commands
available for the MT106-103 card in slot 4, send
the command [HELPC4]. The commands along
with a brief description will be displayed in the
Terminal Window.
FEEDBACK COMMANDS
The next several commands are a function of
both the card and the front panel and are only
available with MultiTasker Front Panel systems
that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
Send the command [VER] to the system and the
feedback will include the following:
690-0122-015 690-0123-004 690-0124-018
Check the last three digits against the numbers
above to determine if the option is available.