Step 3: testing the thermostat – Robertshaw 8405-1 User Manual
Page 7
7
Step 3: Testing the Thermostat
WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS
VALVE OR SYSTEM CONTROL TO TEST OPERATION. THIS WILL
DAMAGE THE THERMOSTAT AND VOID YOUR WARRANTY.
1. Put the HEAT-OFF switch into the HEAT position.
The will
be
displayed.
2. Press the
button until the temperature setting is at least 3
degrees above room temperature. The heating system should turn
on. The fan may not turn on immediately, depending on the fan
delay built into the furnace.
3. Put the HEAT-OFF switch into the OFF position.
The heating system should turn off. The fan may
continue to run for a short period of time.
4. Put the AUTO
ON switch into the ON position.
The blower fan should turn on.
The display will show a
.
5. Put the AUTO
ON switch into the AUTO
position. The blower fan should turn off.
off
heat
!
off
heat
on
auto
on
auto
110-1161.qxd 6/9/05 10:41 AM Page 7