Salamander Designs Synergy System SB339C/B - Manual (Page 3)

B
.
Fine Tuning
Use the bubble level to precisely adjust
the adjustable shelves. Be sure to level
both sides as well as front to back. Use
the hex key to tighten each peg.
A
.
Adjustable Shelves
Place shelves from the bottom up. Angle
the shelf in between the front post and set
on top of shelf pegs. Use the Spacer Tool to
adjust spacing between shelves. Position the
peg through the Spacer and tighten.
C.
Triple-Width Shelf
1
2
3
4
5
6
7
8
9
S20 / SVDO REAR PANEL
41/2"
6"
8"
www. sa la ma nd erd esi gn s. co m
EXTENDED REAR PANEL
S30 / S40 REAR PANEL
SP ACE R TOOL
Place triple-width shelf on center
posts and secure with bolts.
A
C
Doc No. 501-095 /v4.12 339 -3/5
4
Placing Shelves
1
2
3
4
5
6
7
8
9
S20 / SVDO REAR PANEL
41/2"
6"
8"
www.
sa la ma nd erd esi gn s. co m
EXTENDED REAR PANEL
S30 / S40 REAR PANEL
SP ACE
R
TOOL
5
Install Spanner
SP ACE R
Adjust screw
to move in
and out.
A
.
Disassemble cross dowel using
the hex key as shown.
400-080
B
.
Install the cross dowels into both
ends of the spanner post as
shown. Gently tighten the set
screw in place with the hex key.
(Adjust set screw to move dowel
fastener in and out as needed.)
C.
Slide the spanner post into the
front two riser posts.
NOTE:
Raise brackets to
bottom of shelf and
tighten in place.