Salamander Designs Chameleon Collection Barcelona - Manual (Page 2)

Affix socket screw (300-465)
into
second hole from top
on inside of posts. Place
rubber covers (303-375)
on screw heads.
TIP: You may need to wiggle the rear panel to set it into place.
4
Install Door Pulls
5
Rear Panels
Fine Tuning/Tips
Secure pulls with screws
using a Phillips screwdriver.
Locate the rear post channels.
Lead one end of the rear panel into a
post channel.
Compress the rear panel firmly into
the opposing post channel.
Aligning Doors
Infinitely Adjustable Shelves
Assemble loosely as shown.
Insert into post channel and slide to desired height.
Level shelf by adjusting shelf peg positions and
tighten screw using hex key.
Note: Drop-in nut must make a 1/4 turn in post.
Main Adjustment (Side to Side and Up/Down)
Adjustment is made by turning screw (A) in and out.
Dismount Hinge from Hinge Plate
With one hand holding the door open, pull
back on the hinge quick-release lever (B).
Follow these instructions if you wish to adjust your doors.
Speaker Grill Assembly
(Applicable Models Only)
Socket Screw 3/4’’
(300-465) Shelf Peg
Drop-In Nut
(300-565)
Attach the two brackets (303-370) using the wafer-
head screws (300-115) to backside of speaker grill.
Note the “UP” arrow.
Speaker Grille Hardware Bag - PHK-2085
Media Drawer Assembly
Set drawer liner (303-555)
on bottom of tray.
Place media organizer
(303-310).
Note: Horizontal grooves.
Socket Screw
300-465
Bracket
303-370
Waferhead Screw
300-115
Rubber Cover
303-375
Place grill pads (303-545) flush to corner edges.
Grill Pad
303-545
Hang speaker grill on brackets.
NOTE: Remove by lifting up and out.
Media Organizer
Drawer Liner
Door Front
Adjust the tops of the doors to be
parallel to the top of the cabinet.
A
A
B
C
A
B
C
D
A
B
A
A
B
1
2
B