Salamander Designs SA/DS10/B - Manual (Page 2)

2
Shelf Brackets
3
Place Shelf
4
Final Assembly
©2005 Salamander Designs Ltd.. Doc# 500-950 / v6.05 / 2 of 2
Limited Warranty
For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any
damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the
original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via
UPS within the continental U.S.A. only.
Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com
SALAMANDER DESIGNS
SALAMANDER DESIGNS
A. Place the low head screws through the 2 holes of
each shelf bracket and attach loosely to *Flat Nuts.
* If you are installing the shelf to an assembled unit
use the Drop-In-Nuts in place of the Flat Nuts.
B. Insert 2 rubber shelf tabs though the top of each bracket.
C. Slide the flat nuts/bracket down the post channels.
D. Position the brackets close to the top of the center post.
Note:
If installing Doors below the Double-Width Shelf slide
shelf pegs down both sides of center post as door stops.
Shelf rests securely onto rubber tabs and center post.
Secure top with connector bolts.
Use the plastic cap plugs to
conceal center hole.
B A