Salamander Designs CL/WK1 - Manual (Page 2)

3. MARK HEIGHT LOCATION
Move the cabinet from the mounting location. Determine the desired height of the top
of the cabinet (28” (711mm) is common). From this height subtract 2-1/4” (57mm) for
a glass top cabinet or 2-7/8” (73mm) for a wood top cabinet. This will be the location
of the top bracket top hole. Using a level, mark the remaining intersecting locations at
the same height. Add a second mark 3-3/8” (86mm) below the top bracket hole location
for the second fastener for each bracket.
4. DRILL WALL HOLES
Predrill mounting holes 21/2” (64mm) deep using a 3/16” (5mm) bit for wood
construction; 3/8” (10mm) bit for masonry construction.
5. INSTALL WALL BRACKETS
A. Install brackets using lag screws (Do not completely tighten). Washers are provided
only to be used between wall and brackets to correct for uneven wall surfaces.
For masonry insert plastic wall plugs prior to mounting brackets with lag screws.
ADJUST FOR LEVEL
B. Tighten brackets using a level for proper alignment. Install the leveling screws to
bracket without screw protruding through top of the bracket.
7. HANG CABINET
A. Using two people, lift the cabinet placing the rear upper framing member entirely
into the bracket “hook”.
FINE TUNE LEVELING
A. Adjust side to side to position as desired.
B. Using a level, adjust the leveling screws if necessary. Be sure that all leveling
screws are in contact with the cabinet frame.
top bracket hole location
desired cabinet top height
down 2 1 /
4
glass
3 3 /
8
or
2 1 /
4
2 7 /
8
down 2 7 /
8
wood
masonry only
only shim for uneven wall surfaces
8. INSTALL A/V COMPONENTS & SECURE TOP
With the top still removed, configure shelving and install your a/v components. When complete, install
cabinet top.For wood tops, use only the front fastening locations.
Doc No. 500-090/v11.10 ©2010 Salamander Designs Ltd.
LIMITED WARRANTY- For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship.
Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential to our equipment failure. Defective product must
be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in
original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.