Salamander Designs SY/FM1 - Manual (Page 11)

Left / Right and Favorite Position Operation Notes:
The factory settings are made for the maximum left and right stop positions (+/- 30 °) and the
favorite position is preset to the center. You may adjust other stop (left, right) positions and another
favorite position to restrict the movement of the screen during rotation, to prevent collision with objects around it
and to provide for optimum visual comfort. The screen rotation movements occurs only as the left or right
arrow is held down. The movement stops when the key (left or right) is released. Pressing the Up arrow brings
the PILOTMOTION back into its preference position, center. Pressing one of the left or right arrows interrupts the
cycle via which the PILOTMOTION moves back into its preference position.
SYFM1 - 501-620 10/08 page 11 of 12
A
9 Attach IR Sensor -
Motorized Option Only
A. Pull the tab at the bottom of the remote control to enable the battery.
B. Plug in the PILOTMOTION power supply cable.
C. Adjusting the Stops and Preference Position.
To access the program mode press the following sequence:
Left arrow, Up arrow, right arrow, left arrow, Up arrow, right arrow ( , , , , , ).
The PILOTMOTION will make a long beeping sound.
Adjusting the favorite position: Put the PILOTMOTION into the desired position using the left
and/ or right arrows. Once the desired position has been reached, validate by pressing the Up
arrow ( ). ( 2 short beeping sounds: “beep” “beep”).
Adjusting the left stop: Press the left and right arrows ( , ) until the desired position has been
reached. Validate by pressing the Down arrow ( 2 short beeping sounds: “beep” “beep”).
Adjusting the right stop: Press the left and right arrows ( , ) until the desired position has been
reached. Validate by pressing the Down arrow ( 2 long beeping sounds: “beeeep” “beeeep”).
The PILOTMOTION is then set. In the event of a power cut, the settings will be saved. They may be
modified using the same procedure.
,
Note: IR Sensor must be
placed where signal can
be reached at all angles.
10
Programming Remote