Apple Mac Monitor User Manual

Unpacking and wall mounting instructions, Connect your computer, Connect your apple macintosh* computer

Advertising
background image

Unpacking and wall mounting instructions

For the unpacking instructions follow the illustrated steps 1 to 5 printed
on the packaging (outside and inside).
For the wall mounting instructions follow the illustrated steps 6 to 8
printed on the first pages of this instruction booklet.

Make sure that the wall mount is being fixed securely enough so that it meets
safety standards.The weight of the monitor (excl. packaging) is about 43 kg.

Connect your computer

&

Connect one end of the VGA cable 1 supplied to the video card of the
computer and the other end to the

VGA IN

connector at the rear side of the

monitor. Fix the connectors firmly with the screws on the plug.

é

In case of a Multimedia computer, connect the audio cable 2 to the audio
outputs of your Multimedia computer and to the

AUDIO IN R

(right) and

L

(left) inputs of the monitor.

Connect one end of another VGA cable 3 to the

VGA OUT

connector at

the rear side of the monitor and the other end to the

VGA IN

connector of a

second VGA monitor.

Daisy chaining

The Active Loop Through facility makes it possible to make a daisy chain with
a second VGA monitor.

In case of a Multimedia computer, also connect the audio cables 4 to the

AUDIO L

and

R

outputs of the monitor and to the

AUDIO IN L

and

R

inputs

of the second VGA monitor.

Note: only use the VGA cables supplied or use cables that are specially delivered

with the monitor.

Connect your Apple Macintosh* computer

Attention: Macintosh computers with separate H and V synchronisation signals
can be used together with the supplied adaptor. Macintosh computers with
Composite Sync and Sync on Green signals may need a special (not
supplied) adaptor or cable. Contact your dealer.

Connect the supplied switchable adaptor for Apple video connectors to one
end of a VGA cable.

Put the DIP switches on the adaptor in the following positions :

1

2

3

4

off

off

on

on

Connect the end of the VGA cable with the adaptor to the video card of the
computer and the other end to the

VGA IN

connector on the back of the

monitor.

Screw the connectors down firmly.

* Apple Macintosh is a registered trademark of Apple Computer, Inc.

1

15-pin D sub

(2-row)

15-pin mini D sub

(3-row)

a

MAINS INLET

VGA IN

AUDIO IN

L

R

VGA OUT

5

1

3

2

4

2

AUDIO OUT

Advertising