Schlage BE469NX User's Guide - Manual (Page 13)

13
ENGLISH
FACTORY DEFAULT RESET
The lock must be set up again after the reset is complete:
1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the Default User Codes into the lock.
See Default Codes Locations on page 10.
4. The lock will perform a setup routine. Wait until
the bolt stops moving before continuing.
NEXIA™ HOME INTELLIGENCE FUNCTIONS
Z-Wave Function Descriptions
Enroll the Lock Turns the Z-Wave radio on and
enrolls the lock.
Verify Lock
Enrollment Verifies that the lock is
enrolled in a Z-Wave network.
Unenroll the Lock Unenrolls the lock and turns
the Z-Wave radio off.
To Enroll/Unenroll the lock, you must first put your Nexia Home Bridge into
enrollment mode:
1. Install a fresh, high-quality 9V battery into the Bridge.
2. Hold the Bridge within 6 feet (1.8 meters) of the lock throughout the entire Enrollment
process.
3. Press and release the plus (+) button (to Enroll) or the minus (-) button (to Unenroll) on
the Bridge. Complete step 4 within 30 seconds.
L This procedure will vary with controllers from other manufacturers.
4. Extend the bolt on the lock and then perform the following:
Enroll/Unenroll
the Lock 6 Digit
Programming
Code
OR
The lock was
Enrolled/
Unenrolled
The lock was
not Enrolled/
Unenrolled
To verify Enrollment:
1. Remove the battery cover. See Replacing the Batteries on page 5.
2. Disconnect the battery connector.
3. While watching the Inside Schlage Button, reconnect the battery connector.
4. The Inside Schlage button will blink if the lock is Enrolled.
L For more information about Nexia Home Intelligence,
please browse to www.nexiahome.com.
L The Z-Wave radio is disabled by default to conserve
battery life. When the lock is enrolled for the first
time, the radio is automatically enabled.
L If you no longer wish to use the Nexia Home
Intelligence System, make sure to unenroll the lock
to conserve battery life.