Securitron CCB_Series User Manual
Slave board master board
Securitron Magnalock Corp.
www.securitron.com
ASSA ABLOY, the global leader
Tel
800.624.5625
in door opening solutions
© Copyright, 2011, all rights reserved
PN# 500-10350
Page 1
Rev. B, 07/11
CCB-8-12 / CCB-8-24 SLAVE BOARD
INSTALLATION INSTRUCTIONS
1. DESCRIPTION
The CCB-8-12/24 allows the addition of eight individually Polyswitched outputs to an existing
power supply. The power supply’s total current capacity remains the same. The CCB-8-12/24
may be installed into the existing power supply enclosure via the provided snap-trak. The CCB-
8-12/24 is not compatible with the Securitron 1 amp power supply.
H
N
G
AC
FUSE
DC
FUSE
P1
P2
P3
P4
P5
P6
P7
P8
R1
R2
R3
R4
R6
R7
R5
R8
-
+
-
S
+
S
P1
P2
P3
P4
P5
P6
P7
P8
R1
R2
R3
R4
R6
R7
R5
R8
-
+
-
S
+
S
SLAVE BOARD
MASTER BOARD
BLACK WIRES
RED WIRES
Figure 1
2. INSTALLATION & WIRING
It is recommended that the CCB-8-12/24 be mounted below the main distribution board. The
CCB-8-12/24 comes standard with four 8” flying leads. Prior to installation, ensure that you
have the correct version of the CCB board for the power supply as they are available in 12 VDC
or 24 VDC.
The CCB board has 4 wires (2 red wires and 2 black wires) which must be soldered to the main
distribution board. Remove AC power and disconnect the battery leads from the battery before
soldering. The 2 black wires should be soldered to the main board’s “S-” solder points. The 2
red wires should be soldered to the main board’s “S+” solder points (as shown in Figure 1).
Note: Any modification to the Power Supply including the addition of the CCB will void
the UL Certification.