SecurityMan ClearCam II - Manual (Page 16)

17
B) Setting up the Camera
1) Set the camera to desired Dip-Switch Channel Frequency
2) Place the camera in a desired location.
3) Plug the power adapter jack into the power jack
4) Plug the power adapter to any AC/DC outlet
5) Jot down the Dip-Switch Channel of each camera. (The receiver
will receive signal from the corresponding camera and display
one at the time. For example, Channel 1 light on the receiver will
display the image from Camera 1 only).
C) Setting up the Receiver for manual or loop mode
1) Basically, the receiver is already set to match the camera by
default(CH1 & Manual). To setup "Loop" mode the A B switch
to "Loop" located at the rear of the receiver.
Note: only use "Loop"mode if two cameras are in used.
1 2 OG
1
2
OG
ON GDH02
Power Jack
Default Mode