American Audio 100MP3 - Manual (Page 24)

PITCH ADJUSTmENTS
© American Audio ® - www.AmericanAudio.us - Flex 100MP3 Instruction Manual Page 24
2. PITCH BENDING:
Unlike the pitch Slider (7) adjustment t his function will momentarily increase or decrease a tracks speed
during playback. There are two ways to operate this function with the (-) & (+) pitch ButtonS (11) or with
the jog Wheel (14). The maximum pitch bend percentage allowed is +/- 100%. The pitch bend function will
work in conjunction with the pitch Slider (7) pitch setting. For example, if the pitch Slider (7) is set to a
2% pitch gain the pitch bending process will begin at 2% and wi
ll continue to the maximum of + /- 100%.
NOTE: A -100% pitch manipulation will stop playback entirely.
Holding down or tapping on the (+)
pitch Bend Button (11) will pro-
vide a speed bump in the playback
pitch.
Holding down or tapping on the (-)
pitch Bend Button (11) will pro-
vide a slow down in the playback
pitch.
PITCH BEND BUTTONS (11):
The (+) pitch Bend Button (11) will increase track playback speed and the (-) pitch Bend Button (11)
will decrease track playback speed. The extent to which the speed changes is proportionate to the amount
of time the button is pressed. For example, if the (+) pitch Bend Button (11) is held down continuously as
in figure 31, the disc speed will increases and will continue to increase until it reaches a maximum of 100%
speed gain. When you release the (+) pitch Bend Button (11) the disc speed will automati
c
ally return to
it’s previous set speed.
Adjusting the PITCh SLIDER'S RANgE (1): You may change the
pitch Slider'S (7) operating range at any time. To change the operating
range be sure the pitch function is turned on, see figure 28. The pitch per-
centage can be changed between +/-4%, +/-8%, +/-16%, and +/- 100%.
4% will allow the least amount of pitch manipulation and 100% will allow
the most amount of pitch manipulation. To adjust the different ranges,
press the pitch on/off Button (3) and tap on the pitch range But-
ton (1) until your desired value is reached, see figure 30.
Figure 30
Figure 32
Figure 31