Audiovox PCD163 - Manual (Page 5)

PCD163
5
Antenna Connector
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type (AGC) and amperage.
Using an incorrect fuse could
damage the radio.
Amplifier Wiring
Connect rear line out for
optional external amplifiers.
The red connector is for the
right and the white
connector is for the left.
Gray
+
Blue
Black
Yellow
Red
White/Black (-)
White (+)
Gray/Black (-)
Gray (+)
Violet (+) Green (+)
Green/Black (-) Violet/Black (-)
LF/AVG RF/AVD
LR/ARG RR/ARD
15A
0.5A
WIRING
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to
wire exactly as shown
may cause electrical
damage to the radio.