Amana W10180837A - Manual (Page 7)

7
ELECTRONIC OVEN CONTROLS
Display
When power is first supplied to the appliance, a flashing time will
appear on the display. Press CANCEL/OFF to clear the display.
If a flashing time appears at any other time, a power failure has
occurred. Press CANCEL/OFF and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
Start
The Start pad begins any oven function, except kitchen timer. If
the Start pad is not pressed within 5 seconds after pressing a
function pad, the “START?” or “PUSH?” indicator light will
appear on the display (on some models).
If the Start pad is not pressed within 1 minute after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.
Cancel/Off
The Cancel/Off pad stops any function except the Clock, Timer,
and Control Lock.
Clock
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the TEMP/HOUR “up” or “down” arrow pads to set the
time of day.
3. Press CLOCK or START.
On some models, clock display can be turned off or on by
pushing and holding CLOCK.
Range Lights
Oven Light
While the oven door is closed, press OVEN LIGHT to turn the
light on and off. The oven light will come on when the oven door
is opened.
Tones
Tones are audible signals, indicating the following:
Basic Functions
One tone
■ Valid pad press
■ Oven is preheating (long tone)
■ Function has been entered
■ Reminder (on some models), repeating each minute after the
end-of-cycle tones
Three tones
■ Invalid pad press
Four tones
■ End of cycle
Reminder Tones: The audible tones at the end of the Timer may
be set to beep once or continue to beep. Press and hold TIMER
for 5 seconds to enter Options mode. “Opt” will appear on the
display. Use TEMP/HOUR to cycle through the options until you
reach “b” or “b1” (depending on your model). Cycle on and off
using TIMER. Press CANCEL to exit the mode.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To change: Press and hold BROIL for 5 seconds. A tone will
sound and “°C” or “°F” will appear on the display. Repeat to
change back to Fahrenheit.
To exit mode, press CANCEL/OFF.
A. Oven light
B. Clock
C. Oven display
D. Start/control lock
E. Cancel/off
F. Temperature/time
G. Broil
H. Bake
I. Timer
A B C D E
F H G I