American International Electric SEG-M - Manual (Page 25)

Here is a brief description of each menu and sub option, and what the default values should be. The SEG device is factory set to have
the highest security possible. Changing any options, especially in the 'Security' menu could result in not having a completely secure
environment.
0 – Sever Configuration
IP Address
(XXX).(XXX).(XXX).(XXX) Allows you to set the IP address of the SEG directly. You
can set it to 0.0.0.0 to allow it to be served a dynamic IP address each time it boots up.
The IP address should only be set to 0.0.0.0 if the DHCP server is assigning the same IP
address to this SEG device every time, by way of using a non-expiring IP address lease
that is assigned to the MAC address of the device.
Set Gateway IP Address
N (Do Not Change); The term 'Gateway' here refers to a network router on the LAN not
the device you are configuring here.
Netmask 0 (Do Not Change)
Change Telnet Config Password N (it is recommended that you change this option to Yes, and then set a 4 digit password)
1 – Channel 1 Configuration: Settings of the RS-232 Port
Baud Rate 1200 (Do Not Change)
I/F Mode 4C (Do Not Change)
Flow 00 (Do Not Change)
Use UDP Y (Do Not Change)
Source Port
09997 (If there is a need to change this then make sure to change the site settings within
Hub Manager Professional to match)
Destination Port 00000 (Do Not Change)
Destination IP 0.0.0.0 (Do Not Change)
2 - Channel 2 Configuration: Settings of the RS-485 Port
Baud Rate 19200 (Do Not Change)
I/F Mode 4C (Do Not Change)
Flow 00 (Do Not Change)
Document Number: 6066005, Rev 3.2 Page 25 of 34