Sonnet Technologies Fusion QR (Without Drives) - Manual (Page 6)

Install Drives
1. Remove the Fusion QR from its packaging, and place it on a flat,
level surface, with the front panel facing you.
2. Lift up the front of the enclosure, slide the inner chassis lock
switch to the left and hold it (Figure 1), and then push the inner
chassis from the back until it stops (Figure 2).
3. Pull the front panel toward you, and then lift it off of the
enclosure (Figure 3). Set the panel aside.
4. Turn a drive tray’s thumbscrew counter-clockwise until it pops
out, and then pull out the tray by the thumbscrew (Figure 4).
2 – Drive Installation and Enclosure Setup
2
Figure 2
Figure 1
Figure 4
Figure 3
push the inner
chassis in until
it stops
pull out the top
edge, and then
lift off the cover
slide lock switch to
left, and hold it