Drive installation and enclosure setup – Sonnet Technologies Fusion 400 (Version 2) User Manual
Page 5
Advertising
7. Connect the supplied eSATA data cables between the enclosure
and the SATA host controller in your computer;
verify the con-
nectors are plugged in securely (Figure 7).
8. Connect the supplied power cable between the Fusion 400 and a
grounded wall outlet or power strip;
verify the cable is plugged
in securely.
9. Push the switch on the back of the enclosure to the ON position,
and then power on your computer.
10. Format the drives installed in the Fusion 400 according to your
needs; refer to your operating system’s software guide or help sec-
tion for more information.
Figure 7
Drive Installation and Enclosure Setup
4
eSATA data cable
Advertising