Sonnet Technologies Fusion RX1600RAID (With Drives) - Manual (Page 6)

Enclosure Setup
6
2. Connect the data cables’ remaining connectors to the mini-SAS
ports on the Sonnet RAID controller card; verify the connectors
are plugged in securely (Figure 11).
3. Connect the supplied power cables between the Fusion
RX1600RAID enclosure and a grounded wall outlet or power
strip;
verify the cables are plugged in securely.
4. Push the power switch on the front of the enclosure, and then
power on your computer.
How to Connect Fusion RX1600RAID Expansion Systems
This section explains how to connect Fusion RX1600RAID Expansion
Systems to your system. Perform all steps listed here with your
computer and Fusion storage systems powered off.
1. Perform all of the steps from sections A – D with the Fusion
RX1600 Expansion system.
2. Connect the included mini-SAS to mini-SAS data cables between
the expansion (EXP LNK) mini-SAS ports on the Fusion
RX1600RAID enclosure the primary (PRM LNK) mini-SAS ports
on the RX1600 Expansion system.
3. You may additional RX1600 Expansion systems by connecting
data cables from one enclosure’s expansion ports to another
enclosure’s primary ports.
Figure 11
mini-SAS
connector
mini-SAS
connector