Inter-M LM-8000 - Manual (Page 13)

11 LM-8000(REMOTE CONTROL WITH AUDIO IN)
- You can select BGM or adjust BGM output volume of
using a LM-8000 if a DOT(.) is displayed on the LM-
8000 BGM Display Window.
- You may endow with or release the control right of
LM-8000 using the WALL CTRL button on the front
side on the PX-8000. If the right is endowed to LM-
8000, the button of PX-8000 lights and DOT(.) is
displayed on the LM-8000 BGM Display Window.
- Check connection status and the unit if “E” continues
to flash on the display window.
※Turn the encoder volume clockwise until checking
is done that volume is changed since volume is set
to minimum for the initial use.
■ ■ ■ CHANGE OF MAIN BGM AND ADJUSTMENT OF
VOLUME IN OUTPUT AREA USING LM-8000
- Endow with the control right of LM-8000 by pressing
the WALL CTRL button of PX-8000.
- Check that the BGM number is changed, by
operating the BGM Selection Button of LM-8000.
- Same BGM number is displayed on the front BGM
Display Window of PX-8000 and LM-8000.
- Adjust local output volume using a volume adjustment
encoder.
※The volume adjustment encoder of LM-8000 and
the slide volume (FADER) on the front side of PX-
8000 unit control the BGM broadcasting volume of
the output area. A paging MIC broadcasting and
the local output volume of RM-8000 are not
controlled with the encoder and the slide volume.