Inter-M HDCC-400 - Manual (Page 37)

RS232
When you control the PTZ camera by the DVR, follow as below.
1. Connect RS232 cable between RS-232 Port of DVR and DVR port of the J-box. (This connection enables
DVR control remotely from KBD controller)
2. Connect RS485 cables between the DVR and PTZ cameras.
3. Connect the power jack to the power port of the keyboard.
A. Input password (Factory setting is 9 9 9 9 )
B. Open the menu of the KBD controller by pressing CTRL + MENU Key.
C. Set as below in Network menu.
Note: The baud rate of DVR/AUX should be the same as one of the RS232 of the DVR
4. How to setup DVR:
D. Switch the DVR on.
E. Enter the Menu according to the DVR’s instruction manual.
F. Change the Port to “RS232” of the remote control in the devices menu.
G. Confirm matching the setup of RS232 with the keyboard.
Ex: Baud Rate:9600,Data Bit:8,Stop Bit:1, Parity:None)
H. Change the Remote Control to “Remote Control2” in the devices menu.
I. Change the Port to “RS485” in the PTZ menu of the camera of the devices menu.
J. Confirm matching the setup of RS485 of the PTZ menu with PTZ cameras.
K. Set the PTZ menu according to PTZ cameras.
Note: The baud rate of all PTZ cameras should be used one speed type
Set Baud Rate
DOME1 : 9600
DOME2 : 9600
RS232 : 9600
Com Ports
DOME1 : NONE
DOME2 : NONE
RS232
: DVR5
(ex. All 9600 or all 2400)
Note: The product of FASTRAX should be used “FASTRAX2”
L. Set the ID number according to PTZ cameras.
M. Set the system ID number to 1.
6.4 DVR5 protocol for the DVR for the version 3.1.0 and over
Installation of the DVR5 protocol when one DVR is used.
Note: When you set the protocol to DVR5, the keyboard operates as the DVR’s keyboard only and you must
install domes to the DVR only.