Inter-M TU-6200 - Manual (Page 9)

STEREO TUNER
7 TU-6200
Connecting Antenna Connecting Antenna
1. FM ANTENNA
Due to its property, FM broadcast frequency will be weaker in valley, surroundings of building, reinforced
building, etc. install the antenna by considering frequency strength or surrounding situations.
2. INSTALLATION OF FM ANTENNA
Connect to FM antenna terminal as shown in the below figure, and decide the installation position and
direction to make reception good while listening the broadcast. Noise may occur in the downtown area and
a section of a city, industrial complex where traffic is heavy and near power line even if FM exclusive
antenna is used. Use coaxial cable of 75Ω.
3. AM LOOP ANTENA
Connect to AM antenna as shown in the figure, then move the antenna and set to make reception good. If
broadcast is not received well, connect AM FLEM antennal (Vinyl coated line) to the antenna terminal.
4. AM LEAD ANTENA
Make 6~8m of vinyl coated line of single phase, then fix one side to AM terminal and other side to higher
location like wall, etc.
5. AM EXTERNAL ANTENNA
If broadcast is not received well even if lead antenna is installed in the room, install the vinyl coated line in
the outside.