Inter-M DPA-430H - Manual (Page 9)

MULTI CHANNEL POWER AMPLIFIER
7 DPA-430H
Rear Panel Rear Panel
1. INPUT TERMINALS
Connect signal input cables to these terminals.
The input circuitry is balanced type. (+ : Hot, - : Cold, GND: Ground)
2. SPEAKER OUTPUT TERMINALS
Connect speaker cables to these terminals.
Only connect speakers with an impedance equal to or greater than those specified below.
NOTE: Connecting speakers with a smaller impedance than specified could damage the unit.
3. FAN
It is the cooling fan vents.
When inner temperature reaches the certain level, the speed of the fan gets faster.
Please give attention not to block the vents when install the unit.
4. AC INLET
Connect the supplied power cord to this inlet.
1 2 3 4
Country Speaker Output Speaker Impedance (CH1~CH4)
Europe 100V 33.3Ω
USA /Canada 70V 16.3Ω