Alpine CDA-7892E - Manual (Page 6)

4
-EN
Basic Operation
POWER RESET
Detaching the Front Panel
1
Press and hold the POWER button for more than 3
seconds to turn off the power.
2
Press the (Release) button at left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
NOTES
• The front panel may become hot in normal usage (especially
the connector terminals on the back of the front panel.) This is
not a malfunction.
• To protect the front panel, place it in the supplied carrying
case.
Attaching the Front Panel
1
First, insert the right side of the front panel into the
main unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks firmly
into the main unit.
NOTES
• Before attaching the front panel, make sure that there is no
dirt or dust on the connector terminals and no foreign object
between the front panel and the main unit.
• Attaching the front panel carefully, holding the sides of the
front panel to avoid pushing buttons by mistake.
2
1 1
Initial System Start-Up
Be sure to press the RESET switch when using the unit
for the first time, after installing the CD changer, etc., or
after changing the car battery.
1
Make sure that the power of the unit is off. If the is on,
press and hold the POWER button for at least 3
seconds to turn off the unit.
2
Press the RESET switch with a ballpoint pen, or any
other pointed object.
Turning Power On and Off
1
Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except
the eject c and CLK/TITLE buttons.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the POWER button for at least 3
seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level
12.
• Controllable with Remote Control
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine dealer.
• Point the optional remote control transmitter at the
remote control sensor.
MODE (Rotary encoder)
CLK MUTE ANGLE 8 9
Remote control sensor