ION Audio Docs 2 Go - Manual (Page 6)

6
CARE INSTRUCTIONS
CLEANING
For the best scanning quality, please follow these
steps to clean the scanner.
Notes:
• Make sure there is no dust or dirt on the cleaning
paper or cleaning strip.
• Do not use any solvent to clean the sensor.
1. Click the top right corner in the DOCS2GO app
to reveal the “cogwheel” (Settings menu).
2. Tap the cogwheel to go into the Settings menu.
3. Insert the supplied cleaning paper into the
scanner's FEED SLOT with the sponge side
facing DOWN and toward you as if you were going to scan it.
4. Press the Clean menu button in the app. On the next screen that appears, press
the Clean button to begin cleaning.
USING THE CLEANING STRIP
1. Power off the scanner.
2. Hold the grip handle of the cleaning
strip with the sponge side facing
DOWN.
3. Insert the cleaning strip firmly into the
exit slot with the fabric side facing
UP.
4. Push the cleaning strip all the way to
the end of the exit slot.
5. Move the cleaning strip from one side to the other slightly a few times, then
remove it.
CALIBRATION
1. Click the top right corner in the DOCS2GO app to
reveal the cogwheel. (Settings menu)
2. Tap the cogwheel to go into the Settings menu.
3. Remove thin plastic layer on both sides the
calibration paper. Insert the calibration paper (with
the printing side facing UP) into the FEED SLOT.
4. Press the Calibrate menu button in the app.
5. Press the Calibrate button to begin the calibration
process.