ION Audio Replacement Belt - Manual

1
ION Turntable Belt Replacement Guide
To re-attach a turntable belt on your ION turntable, follow the procedure below:
1. Disconnect the power cable from the turnable.
2. Remove both the record, and the slipmat from the turntable.
3. There is a clip located over the middle of the spindle. You will need to remove
this clip before you can take off the platter. A flathead screwdriver can be used
to gently push the clip off the middle spindle.
4. Remove the platter by pulling it straight up, and over the spindle.
5. Place the platter upside down on a flat surface and position the belt so that it is
wrapped around the underside of the platter’s inner ring, centered straight and
free of any twists.