Ariston L 63 B-S-W - Manual (Page 6)

ARISTON DISHWASHER - User Manual 5
www.aristonappliances.us
You have loaded your dishes and you now have to set
the wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
You can cancel the
wash cycle in progress,
if it has only just started.
Make sure the wash
cycle has ended before
removing the dishes!
If opening
the door
soon after
the end of the
program, or during it,
stand away from the
Dishwasher, to avoid
possible injury from
hot steam.
After performing all the
operations described in the
previous paragraphs press
on-off button "A": indicator
light "B" comes on.
Selecting the wash cycle.
To select the wash cycle,
turn knob "D" clockwise
until the reference notch
on the knob corresponds
with the number or symbol
for the cycle you wish to
set (have a look at the
wash cycle table on page
7).
After a few seconds, you
will hear a short beep: the
wash cycle has begun and
we do not recommend you
change it.
The dishwasher keeps you
informed.
Your dishwasher is fitted
with indicator lights (G)
which light up to indicate
the cycle phase under way.
prewash,wash,rinsing,
drying.
At all times, your
dishwasher tells you which
cycle phase is under way.
Modifying a wash cycle in
progress.
If you have chosen the
wrong cycle, not to worry!
You can modify the wash
cycle in progress, if it has
only just started. Turn the
knob counter clockwise
until it reaches the Reset
position and, after a few
seconds, you will hear 4
beeps and indicator light
"G" will turn off. This is to
inform you that all the
settings have been
cancelled. You are now
free to re-set the correct
wash cycle.
You've left out a dish?
Well, it happens to
everyone.Interrupt the
wash cycle by pressing the
ON-OFF button, insert the
dish you had forgotten and
press the ON-OFF button
again. The cycle will start
up from where you
interrupted it.
Finished?
The end of the wash cycle
is indicated by two short
beeps and the flashing of
the drying phase indicator
light.
Turn the knob counter
clockwise to Reset in order
to reset all the settings.
Press the ON-OFF button
as well, thus cutting off the
electricity supply to the
appliance.
If accessible turn off the
water tap.
Wait a few minutes before
unloading the dishes: they
are very hot! If you wait a
little while, they dry better
thanks to the steam.
Empty the lower rack
first.
There's been a power
failure? Have you opened
the dishwasher door?
The wash cycle stops and
then restarts when the
electricity comes back on
or when you shut the door.
Everything is under control!