LevelOne FCS-5052 - Manual (Page 40)

- 36 -
EasyLink
The IP Camera is bundled with free Level1DNS TM service which allows users to assign a unique
user name to their network camera’s IP address. There is no need to configure the router to
open up ports or remember hard-to-memorize IP addresses. The default domain name is MAC
address, you can also register your own name on-line but it have to check the available first.
1. Check the box to enable EasyLink function.
2. If Auto mode is selected, the following page will be displayed.
NOTE - This mode is recommended.
3. Enter a unique EasyLink name whose length must be between 5-32 characters. Verify
that the EasyLink name is available.
Click Apply to apply settings or Cancel to cancel changes.
NOTE - The EasyLink function will not work if the following conditions occur:
1. The camera cannot be located behind a double NAT network.
2.
The camera’s IP address cannot be assigned to specific port numbers using the router’s
port forwarding.
3. EasyLink uses UPnP to exchange port information with the router. The camera must be
connected to the internet through a router which supports UPnP.