LevelOne FSW-1671 - Manual (Page 15)

11
Load default setting
Clicking the “load” button will make the switch being set to the original configuration.
Note: It exclude to change user name, password and IP configuration.
If you want to restore default setting including IP and user name password , then you
can press the reset button for hardware base reset. More for detail information, you
can refer to Load Default Setting –Hardware Base.
Firmware update
Before the firmware update procedure is executed, you should enter the password twice
and then press “update” button. The smart switch will erase the flash memory. There is
a self-protection mechanism in the Boot Loader, so the Boot Loader will keep intact.
Even though the power is turned off or the cable link fails during the firmware update
procedure, the Boot loader will restore the code to firmware update page.