LevelOne GSW-5150 - Manual (Page 10)

6
GSW-5150 48-Port Fast Ethernet +3-Port Gigabit
 LED indicators
The LED indicators include Power, Link/Act, 1000Mbps and 100Mbps LED
indicators, which are used for monitoring and pre-troubleshooting of the Switch.
The following section shows the LED indicators for the Switch along with an
explanation of each indicator.
 Power LED: This indicator will light solid red when the Switch powers up. If the
LED is not lit, please check the power supply and connection.

1000M LED: The corresponding gigabit port LED indicator will light solid green
when the gigabit port connected to a 10/100/1000Mbps device. It flashes
green when data is being transmitted or received on the working connection.

100M LED: The corresponding 100M port LED indicator will light solid green
when the 10/100M port connected to a 100Mbps device. It flashes green
when data is being transmitted or received on the working connection.

SFP LED: The SFP LED indicates SFP module Link/Active status. The LED
indicator will light solid green when the SFP port connected correctly It flashes
green when data is being transmitted or received on the working connection.
3.2 Rear Panel
The rear panel of the GSW-5150 only features a power receptacle, which is an AC
power receptacle. Connect the female of the power cord head here, and the male
head to the AC power outlet.
100-240V 50-60Hz 0.6A ~
Figure 3-2 GSW-5150 Switch Rear Panel sketch