LevelOne AVE-9316 - Manual (Page 10)

10
Receiver’s connected monitor and speaker.
(5) Problem and Solving: If you find unstable image or audio problems after installation,
please confirm following list or contact your direct vendor for further assistance:
A. Check if PC’s VGA resolution and frequency over the limit of monitor display, if so,
please change the VGA configuration from Windows Control panel.
B. Try to connect Monitor and speaker directly to a PC, and ensure the basic function of
these devices.
C. When using LCD or same type monitor, there might have some image offset or
blinking, please adjust the position, clock or phase of the LCD monitor, or simply
press “Auto Adjust / Tune” to have a better image solution.
3. Multi-Port Model: Installation and Operation
(1) Site Selection: In your first time installation, place Transmitter near the PC or A/V devices;
you can use rack-mount kit to fix the system box.
Rack-mount Kit for Multi-Port Unit
(2) Connecting Monitor and Speaker: Plug power adapter to the Transmitter and connect
monitor and speaker to “VGA/AUDIO OUT” port. The POWER LED will turn on green to
indicate the POWER ON status. Then, prepare VGA and audio cables to connect the
signal from your A/V device to the “VGA/AUDIO IN” port of Transmitter box.
(3) Local Function Test: Power on your A/V device, and you should ready to do A/V
broadcasting.
(4) Receiver Installation: Please follow previous section 2 for AVE-9300 to install the Receiver,
and the maximum extended length of this section should not exceed 300 meters.
(5) Repeater Installation: If you wish to have more A/V displays, you can use Repeater, you
may use 4-Port Repeater model to expand one A/V signal to 4 A/V signals. In the other way,
you may stack more Transmitter through their local A/V port to generate more A/V RJ-45
outputs locally and the maximum local stacking capacity is limited to 4 layers to ensure
good broadcasting quality.