LevelOne HVE-0201 - Manual (Page 5)

4
Installation
1. Put ‘TX’ module near to HDMI signal source, such as
DVD players or computers.
2. Put ‘RX’ module is near to HDMI sink, such as LCD
TVs or Projectors.
3. Connect two place by using multimode fiber of 2
cores.
4. Scour the all end face of fibers. (See Note 1)
5. Plug in the fibers according to the indicated number.
The ‘1’,’2’.
6. Plug in the 5V adapter to the electricity and TR/RX
modules.
7. Link TX module to HDMI source by a HDMI cable.
(See Note)
8. Link RX module to HDMI sink by a HDMI cable. (See
Note)
Note
1.
Clean end face of fiber before plugging in. The dust
will cause damage to the fiber.
2. The length of HDMI cable should be NOT longer than
2 meters.
3. These three figures in front of the modules represent
linking status. These 3 LEDs blaze green if all setup is
complete and correct. The left one stands for the
connection of fiber. The middle one stands for the
connection of HDMI source. The right one stands for
the connection of HDMI source.