LiftMaster LA412 Solar Powered Residential Gate Operator - Manual (Page 8)

7
HARDWARE INVENTORY
INTRODUCTION
» HARDWARE INVENTORY + ADDITIONAL ITEMS FOR PURCHASE + TOOLS NEEDED
NOTE: Hardware quantities shown below are for LA412. Quantities are doubled for LA412-S.
Flat Washer 3/8" (3)
Hex Nut 3/8"-16 (3)
Lock Washer 3/8" (3)
Hex Bolt 5/16"-18 x 1-1/2" (1)
Carriage Bolt 3/8" x 5-15/16" (2)
Hex Bolt 3/8"-16 x 1-1/2" (1)
Hex Nut 5/16"-18 (1)
Hairpin Clip (2)
Flat Washer 5/16" (1)
Lock Washer 5/16" (1)
Pin (2)
Keylock Cap
Key (2)
Screwdriver
Adjustable End Wrench
Tape Measure
2 1
Pencil
Carpenter's Level
Clamps
Phillips Head Screwdriver
Deep Well Sockets
and Wrench
1/2", 5/8", 7/16", 9/16"
and 1/4"
Hammer
Drill
Drill Bits
1/2", 3/16", 5/16"
and 5/32"
Wire Cutters (Optional) Wire Strippers (Optional)
Welder (Optional)
ADDITIONAL ITEMS FOR PURCHASE
The following items are REQUIRED to complete the installation:
HARDWARE
• 5/16" mounting hardware for gate bracket.
• The following hardware is needed to mount the control box depending on the
mounting surface:
Wood: Four #8 1-1/4" zinc plated wood screws.
Metal: Four #10-32x6" zinc plated machine screws with nut and lock washers.
Concrete, Brick, etc.: Four 1/4" x 1-3/4" masonry screws.
Post: U-bolt size will vary depending on post. The U-bolt thread sizes for the
control boxes are:
1/4" - standard control box
3/8" - XLM control box CONDUIT
UL Listed outdoor electrical conduit with 3/4" diameter to hold the extension cable
between the junction box and the control box.
ALL MODELS:
LA412-S ONLY:
TOOLS NEEDED
During assembly, installation and adjustment of the operator, instructions will call for
tools as illustrated below.
PHOTOELECTRIC SENSORS
The Model 50-220 photoelectric sensors are intended for installation with the
operators covered in this manual.
To order call 1-800-528-2806 or visit www.liftmaster.com.