Southern Folger 120M DEADLATCH - Manual (Page 2)

A16 Printed in USA FA Rev. 02-10
P.O. Box 2021, San Antonio, TX 78297 s Ph: 210.533.1231 s Fx: 210.533.2211
Web: www.SouthernFolger.com s Email: [email protected]
s Investment-cast stainless
steel strike – Furnished with four
tamper-resistant screws.
s Fractional HP Motor – Permanently
lubricated for smooth quiet operation
with thermal overload protection and
a brake for accurate locking position.
s Finish – Zinc plated case and cover.
Optional Features________
s Faceplate – US32D finish.
s Indication/auxiliary switches –
An indication switch monitors the
deadlock lever indicating a
deadlocked latchbolt. The auxiliary
switch monitors the latchbolt for
extended or retracted position.
s Local electric key (LEK) – A unique
function which uses two types of keys
for applications where inmates carry
their own keys, but supervision is
necessary. One key turns in one
direction only and operates the lock
electrically. The supervisory key turns
in both directions to operate the lock
electrically and mechanically. The
electric operation may be cancelled
from a central console or control point
at any time via a three-position switch.
The Maxi-Mogul
® Key Cylinder is
uniquely suited for this high
frequency operation, shown by cycle
test of 1,000,000 operations.
LEK not available on any 120M-3
Series Locks.
s Key Cylinder Extension – When the
lock is keyed on the stop side of the
jamb, an extension eliminates the
need for a special, recessed frame
pocket. Specify E-3 for 3", E-4 for 4"
or E-5 for 5".
s Optional motor voltage – 24 VAC or
24 VDC.
Specifications_________
s Case and cover – 10 gauge steel.
s Latchbolt – Investment-cast
stainless steel, hardened. 1"
throw.
s Deadlock lever – Stainless
steel, adjustable for door gap
variations.
s Bolt opening – Does not allow
access to mechanism.
s Roller bolt – Investment-cast
stainless steel with stainless steel
roller.
s Operating lever – Stainless steel
to operate with solenoid.
s Strike – Investment-cast stainless
steel, attached with screws in two
directions.
s Motor – 120 VAC continuous
duty, 24 VAC or 24 VDC optional,
synchronous-type gearmotor.
s Springs – Stainless steel.
Electrical
Characteristics________
s AC motors – Synchronous-type
gearmotor with brake.
Ratings: 120 VAC: 60 Hz, 1.3
amps at full load.
s DC motors – Permanent-magnet
gearmotor.
Ratings: 24 VDC, 2.2 amps at full
load.
s Switch – SPDT, UL Listed,
15 amps @ 125 or 250 VAC.
FOLGER ADAM ELECTRIC LOCKS Key: Mogul
Door: Swinging
Security
Level: Medium/Maximum
120M DEADLATCH
MODEL NO.
OPERATION
DESCRIPTION
LATCHBACK
INDICATION SWITCHES
LEK
AVAILABLE
DEADLATCH
120M-1-01 Standard (1) X X Yes
120M-2-01 Knob Release (2) X X Yes
120M-3-01 Key Holdback (3) X X No
Dimensional Data________
Note: Dimensions are for information
and planning purposes only, and should
not be used as templates.
The chart below shows applicability of
above options to all 120M Models.
For complete details, see How to
Specify in this section.