Southern Folger 2B.3 SLIDING DOOR LOCKING DEVICE - Manual (Page 2)

D10 Printed in USA FA Rev. 02-10
P.O. Box 2021, San Antonio, TX 78297 s Ph: 210.533.1231 s Fx: 210.533.2211
Web: www.SouthernFolger.com s Email: [email protected]
s Tamper-resistance – Openings in
housings are baffled to resist inmate
tampering.
s Selective operation – Single or
groups of doors may be
simultaneously opened or closed and
deadlocked.
s Adjustable torque limiter – Simple
adjustment of force exerted by the
door. May be set between 20 and 50
pounds.
s Sloped-top housing – Resists hiding
of contraband. Flat-top housing
provided where device must install
close to ceiling.
s Fixed hinge cover – Allows
maintenance without the need to lift
heavy covers off the device.
s Cover lock – Device mechanisms are
concealed by an outer cover and
unlocked from the release cabinet.
s Automatic deadlocking – When fully
closed or open, independent top and
bottom locking points on the rear of
each door automatically deadlock.
s Indication switch – Monitors the
deadlocked condition of both locking
points.
s Gang release – From mechanical
release cabinet.
s Self-contained – A continuous,
surface-mounted housing contains the
drive and mechanical release
mechanisms and wiring.
s Removable end battens – Simplify
installation of wire harnesses.
s Full length wire tray – Simplifies
routing of electrical wire/harnesses.
Runs the full length of the housing.
Optional Features
s Key switches – May be added in
columns or nearby for local electric
control.
s Two point locking mechanical
release cabinet – A three-position
lever handle or crank handle is
provided.
Lever provides:
1. Electric operation – Door control
from a remote location.
2. Release ports open – Opening of
individual release ports. Doors to
be individually released at the
door with a removable handle.
Covers are also individually
released from the port.
3. Emergency unlock – Gang
release of all doors in event of
emergency or power failure.
s Electrical/mechanical control
cabinet – Electrical switches may be
ordered to provide control of each
door in addition to mechanical
function. These switches may be built
into the same cabinet as the
mechanical levers, or located remotely
as required. The following switch
functions are available:
Three-position operating switches –
(OPEN-GROUP-CLOSE).
Group switch – Provides group
control (OPEN-OFF-CLOSE).
Power cut-off switch – Cuts off
electrical current to controls.
Indication lamps – Red and green
indicator lamps may be installed with
switches to show deadlocked, closed,
or open status of each door.
s Special indication lamps – An
additional (amber) lamp is available.
When used, indication is as follows:
Red - Locked open.
Green - Deadlocked closed.
Amber - Moving, or stopped in mid-
travel.
s Custom graphic controls – In many
cases, it may be desirable to separate
electric controls from the mechanical
release cabinet located near the cells.
For larger installations, or those with
particular needs, custom-built control
consoles may be easily provided with
floor plan graphics screened on the
control panel, and an array of
specialized features.
s Wire harness – For applications using
a series of locking devices, a wire
harness(es) may be specified to
interconnect terminal strips in the
mechanical control/release cabinet to
a plug connector at the door
operating unit. Simplifies routing of
wire, and saves installation cost and
time.
s G90 galvanized finish available.
FOLGER ADAM LOCKING DEVICES Drive: Roller Chain
Release: Remote Electrical &
Mechanical, Local Mechanical
Security
Level:
Maximum
2B.3 SLIDING DOOR
LOCKING DEVICE