Steelcraft Automotive 52050 GRILL GUARD - Manual (Page 2)

Page 2 of 2 10/9/07
(AM)
Passenger Side
Loosen the bumper
bracket bolts and
move the bumper
brackets outboard Once the bottom bolts
are removed, pull the
bumper skin outboard to
un-hook the clip.
Remove these bolts to
remove bumper skin.
Note the bumper in this
figure is faced down.
Mount the mounting
bracket between the
frame and the
bumper bracket
Frame
Bumper Bracket
Factory Bolt
10mm x 40mm Hex Bolt
10mm Flat Washers
Mounting Bracket
Notice the angle of the
brackets faces outboard
12mm x 30mm Hex Bolts
12mm Nylock Nuts
12mm Flat Washers
Grille Guard
Passenger Side
Passenger Side
Passenger Side
Figure 1
Figure 2
Figure 3
Figure 4
Cut a ½” slot from
the bottom of the
hole down to 1 ¾”