Cutting instructions – Steelcraft Automotive 75010 BULL BAR User Manual

Page 2

Advertising
background image

CUTTING INSTRUCTIONS

The template works best is placed on top side-of splash shield (the side towards the vehicle). Locate two-oval slots
that measure'3 10 x 20MM-". Gut out template and place over appropriate slots; Hold in place using masking tape.
Drill 6MM holes at each of the small circles. Cut splash shield from each drilled hole to drilled hole. It may be
necessary to use a straight edge to ensure a straight cut.

/ /























EXOSTOMG SLOT

DRIVER SIDE

TOWARDS

TOWARDS FRONT OF
SPLASH SHIELD

TOWARDS FRONT OF
APLASH SHIELD

TOWARDS CENTER

PASSENGER
SIDE

EXISTING SLOT

Advertising
See also other documents in the category Steelcraft Automotive For the car: