Steelcraft Automotive 72320 BULL BAR - Manual (Page 2)

3” BULL BAR
2011 JEEP GRAND CHEROKEE
Page 2 of 3 12/17/10 (DP)
5. Align and adjust the Bull Bar and tighten all hardware. Reinstall the splash guard removed in
Step 3, (Figure 2).
6. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
Fig 1
Fig 2
Fig 3
(Fig 4) Air deflector pictured from below front bumper
Front
Front
Tow hook mounting location
pictured through opening in
front bumper cover
Remove plastic
splash guard
Separate lower bumper cover from
upper bumper cover at ends only
Remove (3) clips